INTRODUCTION

Batteries currently contain one or more of the following eight metals: mercury, cadmium, lead, zinc, manganese, nickel, silver, and lithium. When disposed of in an unlined landfill, a battery can leach its toxic constituents and contaminate groundwater. Mercury and cadmium pose a special threat in incinerators because they are volatilized by the incineration process. When incinerated, battery contents can be released to the environment as inhalable emissions or as leachable elements from the ash.

To promote recycling and proper management of waste batteries, they have been included in the New Hampshire Universal Waste Rule, which became effective October 13th, 2001.

The New Hampshire Universal Waste Rule is described in this fact sheet. DES believes that recycling is the preferred option for managing waste batteries and that this policy will promote the recycling and proper management of waste batteries.

Universal Wastes
"Universal wastes" are wastes that meet the definition of hazardous waste in the N.H. Hazardous Waste Rules, but which during accumulation and transport pose a relatively low risk compared to other hazardous wastes. Wastes that DES has determined meet universal waste criteria include: used antifreeze, cathode ray tubes, mercury-containing lamps and devices, certain types of hazardous waste batteries, and recalled or suspended hazardous waste pesticides regulated under the Federal Insecticide, Fungicide, and Rodenticide Act (FIFRA).

"Universal waste batteries" are waste batteries that meet the definition of hazardous waste in the N.H. Hazardous Waste Rules. These include nickel-cadmium (ni-cd), small sealed lead acid, and hazardous lithium batteries. Lead-acid motor vehicle batteries may be managed under Env-Wm 809 of the New Hampshire Hazardous Waste Rules or under the Universal Waste Rule. Please refer to the DES fact sheet WMD-SW-4 "Management of Used Motor Vehicle Batteries" for more information. See fact sheet WMD-HW-23 "All About Batteries" for battery identification and disposal information for each type of battery.

Generator Status
Hazardous waste generators are not required to include universal waste batteries and other universal wastes in their calculation of generator status, in accordance with, Env-Wm 503. Universal wastes, when recycled, are not subject to the generator fee under Env-Wm 512.02.

Universal Waste Consolidation
A facility may collect universal waste batteries from other sites or generators without a permit, provided the facility meets the handler requirements of the Universal Waste Rule described in this fact sheet.

REQUIREMENTS FOR SMALL AND LARGE QUANTITY HANDLERS

A "handler" of waste batteries means: : (1) a generator of universal waste batteries, or (2) an owner or operator of a facility that receives universal waste batteries from other handlers, accumulates the waste batteries, and sends the waste batteries to another handler or to a destination facility. Handlers of universal waste batteries must meet the requirements of the New Hampshire Universal Waste Rule, Env-Wm 1101-1114. These requirements include the following.

1. Release Prevention
Manage universal waste batteries in a way that prevents releases to the environment. Any batteries that show evidence of leaking must be stored in a closed, structurally sound container that is compatible with the contents of the battery. This container must not be allowed to leak or spill. See the section titled: "Best Management Practices for Universal Waste Batteries" on page 6.

2. Universal Waste Handlers
Universal waste handlers are either large quantity or small quantity handlers based on the quantity of waste managed.

a. Small Quantity Handlers - may accumulate no more than a combined total of 5,000 kilograms of waste batteries and other universal wastes on-site at any time. Approximately 220 five -gallon pails (about 50 pounds each) or 20 55 -gallon drums (550 pounds each) of waste batteries would equal 11,023 pounds (approximately 5,000 kilograms).

b. Large Quantity Handlers - may accumulate more than 5,000 kilograms, combined total of waste batteries and other universal wastes on-site at any time by complying with the additional requirements for large quantity handlers of Env-Wm 1104 of the Universal Waste Rule. These requirements are described on page 5 in the section titled "Additional Requirements for Large Quantity Handlers."

3. Activities
All handlers of universal waste batteries may conduct the following activities, as long as the casing of each individual battery cell is not breached and remains intact and closed, except that cells may be opened to remove electrolyte but must be immediately closed after removal.

(1) Sorting batteries by type.
(2) Mixing battery types in one container.
(3) Discharging batteries so as to remove the electric charge.
(4) Regenerating used batteries.
(5) Disassembling batteries or battery packs into individual batteries or cells.
(6) Removing batteries from consumer products.
(7) Removing electrolyte from batteries (although DES discourages this activity by handlers due to increased risk).

4. Labeling
Clearly label or mark each battery or container of waste batteries with any one of the following phrases: "Universal Waste - Battery (ies)," "Waste Battery (ies)," or "Used Battery (ies)."

5. Accumulation Time Limits
Waste batteries may be accumulated for no longer than one year from the date the waste batteries are first generated, or received from another handler. The one year time limit may only be extended if longer storage time is required to facilitate proper recovery, treatment, or disposal. However, the need for an extended time must be demonstrated and documented by the handler and approved by the DES.

The handler must indicate the length of time the waste batteries have been accumulated starting from the date the batteries became waste or were received. The handler may accomplish this by:

(1) Marking or labeling containers with the starting accumulation date, or
(2) Maintaining an inventory system on-site that identifies the earliest date waste batteries were added to a container or received from off-site, or
(3) Any other method (including those described in Env-Wm 1102.04) which clearly demonstrates the length of time that the universal wastes has been accumulated from the date it becomes a waste or is received.

7. Off-Site Shipments
Handlers are prohibited from sending or taking waste batteries to a place other than another handler, a battery recycling facility or a hazardous waste treatment, storage or disposal facility.

Prior to sending a shipment of waste batteries to another handler or destination facility, the originating handler must ensure that the receiving handler agrees to receive the shipment.

Shipments must meet all applicable United States Department of Transportation (US DOT) and New Hampshire Department of Safety (NH DOS) regulations for waste batteries.

If a waste battery shipment is rejected by an intermediate handler or destination facility, arrangements must be made by the originating handler to receive the waste batteries back when notified that the shipment has been rejected, or send the waste battery shipment to an alternate facility.

8. Exports
A handler of waste batteries who sends the batteries to a foreign destination must comply with the requirements for international shipments as set forth in Env-Wm 1102.08 of the N.H. Universal Waste Rule.

ADDITIONAL REQUIREMENTS FOR LARGE QUANTITY HANDLERS

A handler may collect more than 5,000 kilograms of combined universal wastes if he/she complies with the handler requirements in this fact sheet and with the following additional requirements.

1. Notifying the DES prior to the start of this activity and obtaining an EPA Identification Number, if one has not already been obtained.

2. Keeping records for three years on each shipment of waste received or sent. These records must include the date of each shipment, the quantities of each shipment, and the name and address of the handler or facility from which waste batteries were received or shipped to.

3. Ensure all employees who handle or have responsibility for managing waste batteries are trained in the handling and emergency procedures appropriate to waste batteries.

REQUIREMENTS FOR TRANSPORTERS

Transporters are not required to obtain a New Hampshire hazardous waste transporter registration or use a hazardous waste manifest for waste batteries, but must meet all applicable US DOT and NH DOS regulations.

Transporters are prohibited from sending or taking waste batteries to a place other than another handler, an authorized waste battery recycling facility, or an authorized hazardous waste treatment, transfer, storage or disposal facility.

Transporters who remove waste batteries from their vehicles and stage them for 10 days or less are not required to obtain a hazardous waste transfer facility permit, but are subject to US DOT regulations and must also meet the universal waste handler requirements.

Transporters taking waste batteries to a foreign destination must comply with the requirements for exports as set forth in Env-Wm 1106.07.

REQUIREMENTS FOR HANDLERS AND TRANSPORTERS HANDLING BROKEN OR DAMAGED WASTE BATTERIES

1. Immediately contain and clean up all releases from broken, leaking or damaged batteries.

2. Place any broken or damaged batteries and any residues resulting from breakage or damage in a secure container.

3. The container must be closed and sealed, structurally sound and compatible with the broken batteries. Ensure the container is clean; if it is contaminated with other chemicals, those substances may react with the batteries.

4. Manage, in accordance with the N.H. Hazardous Waste Rules, any residues resulting from the cleanup of battery spills or leaks that exhibit a characteristic of hazardous waste. The handler is considered the generator of the residues and other cleanup waste and must meet the requirements of Env-Wm 500.

5. Any releases which pose a threat to human health or the environment must be reported immediately to DES at (603)-271-3899, Monday through Friday, 8 am to 4 pm or to New Hampshire Department of Safety (NH DOS) Hazmat Unit at 1-800-346-4009, 24 hours/day and to the municipality in which the release occurred.

BEST MANAGEMENT PRACTICES FOR UNIVERSAL WASTE BATTERIES

Batteries can be potentially harmful when stored improperly. There have been fires in New Hampshire due to improperly stored batteries. Because of this risk, the following additional storage practices are recommended.

1. Store rechargeable batteries that are not fully discharged so that their electrodes do not come in contact with the electrodes of another battery or a metal object (e.g., the inside of a metal drum).

2. Do not tightly seal battery containers. This is to avoid the build up of hydrogen gas.

3. Keep batteries dry. Storage of batteries under a cover or in a building works best, especially since some batteries can react with the water.

4. Store batteries away from sources of sparks or flames.

5. Do not store leaking batteries with non-leaking ones; acids from the insides of some batteries may corrode the other batteries.

FOR MORE INFORMATION

Questions on batteries should be directed to DES's Household Hazardous Waste Program at (603) 271-2047 or the Hazardous Waste Compliance Section at (603) 271-2942.

A list of battery recycling facilities, copies of other fact sheets, or a copy of the N.H. Hazardous Waste Rules are available from DES's Public Information and Permitting Office at (603) 271-2975, (TDD Access: Relay NH 1-800-735-2964). Copies of DES fact sheets and rules are also available on DES's web site at www.state.nh.us/des.

Information on US DOT regulations can be obtained from the N.H. Department of Safety, Hazardous Materials Unit at (603) 271-3349.
 

Disclaimer: Information contained in this fact sheet is current as of March 8,2002. Policy and regulatory changes occurring after this date may affect part or all of this information. For questions on the status of this information, contact DES at 603-271-2942.